Farmall & IHC Tractors Discussion Board |
Re: Hydraulic Plumbing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on May 20, 2001 at 03:38:05 from (63.15.137.160):
In Reply to: Hydraulic Plumbing posted by 1PWRFULH on May 19, 2001 at 20:14:38:
easiiest and best way would have the loader on a circut by itself but a ball valve will work ok as you dont need both at the same time the left rear outlet on the original was a delayed for the rear imps you can run the loader out of one port then a tee to go to the cycls use this set up on my B when want to use blade on back just shut off the line going to the cycls on the loader this also locks the loader in position can also use two way on the blade but all it does is raise up the B nice way to change tires
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|