|
Farmall & IHC Tractors Discussion Board |
Grrrrrr. Got One H Wheel Weight Off
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on May 19, 2001 at 13:45:30 from (12.75.197.115):
HOT DOG! I found a technique that worked quite well. My tendonitis wasn't about to let me pound on those bolts and nuts for very long. I started with a 6 ton hydraulic jack and set it between the bolt/nut head and the side of the drawbar. After breaking the jack (20 years old) I got a 12 ton jack. I would have used a 20 but there is only about 9 1/2 inches of clearance. I pushed out the wheel weight about 1/4 inch then rotate the tire and push out the next one. After I had the weight out 1/4 inch all the way around, I removed the nuts and pushed each bolt/wheel weight about another 1/2 inch. On the third revolution, I pushed the end of the bolts to the hub. I then was able to pull the weight off. You might have to set your jack so the plunger is hanging down low so it will get oil to jack.
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
