Farmall & IHC Tractors Discussion Board |
Re: HELP no lift on three point hitch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KURT on May 14, 2001 at 04:15:41 from (64.109.118.246):
In Reply to: HELP no lift on three point hitch posted by budaa on May 13, 2001 at 16:06:07:
You need to find out what the pressure is in the hydraulic system. I think those are about 2" bore cylinders. A 2" bore will have a total area of 3.14 square inches. Then you will have to find out the force generated take the pressure on the gauge and multiply it by 3.14. If you have 600 psi then you will have 1884 lbs. per cylinder to lift. You may have to adjust the relief valve or you could have an internal pressure leak.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|