Farmall & IHC Tractors Discussion Board |
Re: 48 Cub Good oil preasure for 10-15 Minutes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by p on May 10, 2001 at 10:44:32 from (12.33.190.5):
In Reply to: 48 Cub Good oil preasure for 10-15 Minutes posted by Keith L. on May 10, 2001 at 04:02:34:
I have a 52 Cub that did this. I found out that my bearings were shot. I would say you might have this problem. Also, there is a spring and plug that is supposed to regulat the oil pressure, you may want to pull it out and see if it is cracked or something, but I would doubt it. I would bet that it is your bearings. As soon as the motor warms up the tolerances increase and the oil has not resistance. Mine would drop to idle and the thickness of the oil made no difference. My dad refused to let me tear it apart until after mowing season and therefore we had a really expensive rebuild ahead of us.(ground crank, bored block, new pistons etc.) be careful. and find the problem, it wil not just go away. I would also pull the pan and do a visual check.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|