Farmall & IHC Tractors Discussion Board |
Re: Getting There
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Dave on May 09, 2001 at 08:31:40 from (208.165.46.34):
In Reply to: Getting There posted by Mike Howell on May 08, 2001 at 19:41:22:
Looks Great! I have a '40 B That I restored a few years ago and it's a nice tractor to own and work on. Drives nice and easy, parts are small enough to handle without too much trouble and people can't believe it when you tell them that it is 60+ years old. You will get a lot of enjoyment out of that tractor. How much clearance does that trailer have between the fenders? I looked all over and could not find one like that wide enough for a B. The best I could find had about 75" clearance and I needed 78". Ended up with one that the bed is above the tires. Sits higher than I wanted, but it's 7 feet wide and the B fits on it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|