Farmall & IHC Tractors Discussion Board |
Re: How to separate clutch from flywheel?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on April 27, 2001 at 04:59:39 from (129.37.117.110):
In Reply to: How to separate clutch from flywheel? posted by Lowell Davis on April 26, 2001 at 17:34:51:
Are you saying the clutch is still stuck to the flywheel after you have all the bolts loose?? If so, I guess you need a helper, like a pry bar to jar it loose. Also, I gather you have everything else loose, including the clutch release sleeve carrier that is bolted to the top of the clutch housing. You won't be able to tilt the shaft to get it out until you take that carrier loose. The shaft has to be tilted down before it will come out. You have to pull it back as far as it will go, which clears the pilot bearing, but not the clutch plate. then tilt it down and it should come out. I worked and worked with mine and then all at once it was in my hand! Also, are you sure you have the clutch completely compressed? You can't tilt the shaft unless the clutch is fully compressed.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|