Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Farmall H_Lift-all
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by richard Wurtzberger on April 25, 2001 at 19:32:19 from (206.9.239.130):
In Reply to: Re: Re: Farmall H_Lift-all posted by Bryan Phillips on April 25, 2001 at 16:12:22:
Now that you understand the workings, IH made a 2 way adapter that we have on our Super M. but with no filter in the grim wore it out and it did not hold. We then used an aftermarket valve. Heres how you build your 2 way hydraulic. take one of the ports preferably one that is not delayed and hook it up to the "in" port of a 3 or 4 way valve( a 3way has 1 up 2 hold 3 down a 4 way has 1 up 2 hold 3 down 4 float) such as a Greesen or Cross open center valve with a 1000 psi relief, then from the return "out" side , T it into the fill cap of the Lift All. The other two ports are for your 2 way cylinder. The control rod for the original pump needs to be locked in the raise position to work.Some type of a latch can be used. If you want to, a filter can be placed between the added valve and the return to the fill of your lift all.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|