Farmall & IHC Tractors Discussion Board |
Re: Removing M clutch shaft?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on April 22, 2001 at 14:51:43 from (129.37.117.121):
In Reply to: Removing M clutch shaft? posted by Lowell Davis on April 22, 2001 at 11:33:49:
Before you can get the clutch shaft out, you will have to remove three bolts of the six that hold it to the flywheel. Then reinstall them in the vacant holes that are there with washers under the bolts to compress the clutch. Then you can move the clutch disk around and when you get it in just the right position, it should come out. However, I found there was no way to get it back in, at least I could not until I removed the fork that works the clutch and the cross shaft that it is attached to. It is not hard to remove these and once you remove the clutch fork and the cross shaft and compress the clutch you can tilt the shaft enough to get it out. The manual I had said you could get the shaft out too, but it will not come until you compress the clutch so you can move the disk around.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|