|
Farmall & IHC Tractors Discussion Board |
Super A...Splitting Tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tyler (MD) on April 21, 2001 at 05:09:48 from (207.172.73.227):
Well, and it's a deep subject, I'm going to split the Super A and do some clutch work. I think I have a bad pilot bearing/bushing. I'm having trouble with the imput shaft taking so long to spin down to allow me to put in gear without grinding. Also when I push down on clutch pedal to disengage, there's a slight load on the engine and if I hold down on the pedal for about 30 seconds, some smoke is visible. The release bearing is warm at this time, but not hot enough to smoke. I have greased the bearing carrier, and throw out bearing. I have the idle set properly. I have changed the tranny fluid to the 80/90w stuff. None of this helped much to minimize the grinding. So it's time for some new parts (Rockford clutch, throw-out bearing, pilot bushing, resurface flywheel?). While I'm in there, I need to replace the rear crank seal, it leaks a little. Should I replace any other seals? I need to know some in's and out's as far as splitting the tractor. Any tips or information would be appreciated. I have manuals but would like to get some opinions from fellers that have done the job. I will be working out of a car port with a cement floor. It has no ceiling joists. Thanks in advance for the pointers.
Thanks to GeneB for some previous advice. Tyman
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
