Farmall & IHC Tractors Discussion Board |
Re: Replacing M transmission drive shaft oil seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by R.David on April 20, 2001 at 22:02:22 from (216.37.152.162):
In Reply to: Replacing M transmission drive shaft oil seal posted by Lowell Davis on April 20, 2001 at 15:19:24:
I got into a job like that a few years ago. But I think I was replacing the clutch release sleeve instead. I'm not sure if you have room to get the joint apart without removing the shaft also. I think in order to remove the shaft and sleeve I unbolted and removed the clutch assembly with the shaft and sleeve all at the same time. It's not that hard to do. As long as it's an M and not a Super M. The Super M has a larger clutch and I think it has to be split in order to remove the clutch. Reinstalling the clutch isn't that hard either and the shaft acts as the perfect alignment tool. Good luck. Dave
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|