Farmall & IHC Tractors Discussion Board |
Re: ONE H OF A TIME with H Brakes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom on April 20, 2001 at 10:27:33 from (147.226.5.4):
In Reply to: ONE H OF A TIME with H Brakes posted by Michael Soldan on April 19, 2001 at 18:44:40:
Mike, Just a word of caution. Farmer Bob gave you good instructions. However, if you have trouble removing the old oil seals and think the seals are in a bearing retainer, think again. This pinion housing cannot be removed until you remove the bull gear on each side and drop them out of the housing on the inside. I learned, along with several others, the hard way. Pulling this cast housing with the jack screws will hang on the bull gear and break something, if you do not clear the gear inside first. Your best bet is to be careful and successfully remove the old seals without needing to pull the pinion assemblies. These assemblies are shimed to get proper gear loading and this becomes a whole other project to replace. Good luck, just take your time. Tom
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|