Farmall & IHC Tractors Discussion Board |
Re: Super C crank pulley
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on April 17, 2001 at 18:37:01 from (63.42.174.211):
In Reply to: Super C crank pulley posted by Tim - Maine on April 17, 2001 at 16:41:46:
make sure the set screw is out of the pulley some had one some did not usr a three jaw puller I USE A JACK AND PRESS THEM BACK clean all surfaces and oil them hammering is a good way to break them I made a bracket to press them one as I always seem to be working on them some go on easy and some harder that is why I PRESS THEM ON might take a little time to build a frame to press on with a hy jack BUT it takes time to find another one if you decide to hammer it use a good block of wood and be carefull not to break the cast good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|