Farmall & IHC Tractors Discussion Board |
Re: Hard Starting 706D
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MN Charlie on April 12, 2001 at 10:58:24 from (156.99.90.177):
In Reply to: Hard Starting 706D posted by Craig on April 11, 2001 at 12:52:40:
Jim is right about having the valves placed correctly in the cylinder head. That's where the compression can be lost and that makes any diesel start hard. Craig, as I read your posting you indicated that it starts hard when warm and I'm sure that it gets worst the hotter it gets. Your problem is the injection pump is not delivering fuel to the cylinders when it's hot. Watch the exhaust pipe while cranking and if there is not much smoke when she is warm your problem is the hydraulic head in the injection pump is wore out. When an injection pump shop rebuilds the pump that's one of the checks that is performed on the pump. The pump shop checks the amount of fuel that's being delivered at cranking speed when the pump is hot. Good luck I know what I told you will cost $$$ but that's your problem.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|