Farmall & IHC Tractors Discussion Board |
Re: B Steering Gear Assembly
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave G on April 11, 2001 at 19:37:40 from (158.252.164.161):
In Reply to: B Steering Gear Assembly posted by Red Raider on April 10, 2001 at 19:40:59:
Hey Red - I know just what you are talking about. I recently did 3 B's. The first time I broke the bottom casting with the turning stop lugs on. Here is what I learned: To get the top bearing off I use my press and block up under the gear and press on the top. If you need to heat up the bearing a little. To get the 2nd bearing (big one on bottom) I flip the assembly upside down and press on the bottom casting (plate with turning stop ears)using wood blocks position as close to the center as possible in order not to break it. This is what works for me. It sure feels good to get that seal replaced so it will hold oil again. I'd check & replace bearings if needed while your at it. Heat bearing and freeze shaft to put back together. Make sure you have gaskets, etc. in place before putting bearing back on.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|