Farmall & IHC Tractors Discussion Board |
Re: trans fluid farmall H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on April 11, 2001 at 11:56:11 from (206.246.187.2):
In Reply to: trans fluid farmall H posted by Bruce on April 11, 2001 at 11:13:45:
Bruce use 90W or 85W140. If you are draining the system, it will take 6 gallons. There is the obvious drain plug in the rear. There is also a drain plug on the front of the transmission under the flat plate next to the liftall. That will drain about 2 quarts. Also if you have a flat belt pulley assembly, remove the 4 end bolts and tap that pulley out about 1/4 inch. You will get about 1/2 quart of 90W and WATER. The condensation in the transmission works it's way up into the flat belt pulley assembly. When you get ready to fill the transmission, save 1/2 quart and fill the flat belt pulley assembly. The fill hole is on top of the assembly.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|