Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: C front transmission seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave T on April 10, 2001 at 18:33:21 from (63.27.107.71):
In Reply to: Re: Re: Re: C front transmission seal posted by Haas on April 10, 2001 at 17:01:33:
Haas, Looking at the cross section view in the I&T Service Manual, it appears to be another shaft with a bunch of gears hanging on it. It's lower than the other. It appears to have a bearing plate, and seal too. I'm thinking that this one is below oil level and would leak all the time, and the clutch shaft seal would stop leaking after it sat awhile, because it's above the oil level unless their is no seal there, just a gasket......Dave T
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|