Farmall & IHC Tractors Discussion Board |
Re: Setting the governor on an H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne Swenson on April 09, 2001 at 21:36:54 from (206.8.166.23):
In Reply to: Setting the governor on an H posted by John R. Brock on April 09, 2001 at 10:59:48:
If you have access to a mechanical tachometer, you can go to the belt pulley flange or PTO shaft to take a RPM reading. According to my Serviceman's Guide, the engine should run at 1815 RPM, the belt pulley 1121 RPM, and the pto 594 RPM when the engine is at fast idle.(wide open throttle --no load) The engine runs at 1650 RPM when the throttle is wide open and pulling it's rated load. Idle RPM is 450. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|