Farmall & IHC Tractors Discussion Board |
Re: Carb help IH 354
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob/Maine on April 03, 2001 at 04:48:18 from (209.217.137.167):
In Reply to: Carb help IH 354 posted by Ivan Cousins on April 02, 2001 at 18:51:45:
On my carburetor there isn't any adjustment on the float either. You have to carefully bend the float with a small needle noise pliers. Make sure that the float works smoothly on the pivot shaft and that it doesn't touch the sides when you reassemble it. The book should give you the proper measument of the float. Mine was something like 1 5/16" measuring with the gasket on, upside down, to the top of the float. I believe that I disassembled it and made it another 1/16" lower? You will have to check the spec. for your carburetor, they will be different from mine. Bob
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|