Farmall & IHC Tractors Discussion Board |
Re: Need Super A electrical info
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on April 02, 2001 at 06:46:45 from (129.37.117.101):
In Reply to: Need Super A electrical info posted by Fred Miller on April 01, 2001 at 18:51:49:
If you have a regulator, you do not use the resistor. The resistor is used to set the charge rate when you have the cutout relay and no regulator. On the regulator, field goes to the F terminal on the generator. Gen goes to the Armature (ARM) or gen terminal on the Generator. Battery goes to the hot battery terminal, usually through the ammeter. Battery connected to one side of the ammeter and the regulator "bat" terminal to the other side of the ammeter. The L terminal on the regulator is for "lights" or "load". You do not have to connect anything to it. Normally, the lights are just connected to the battery or to the ammeter terminal. On a 6 volt, usually the system is positive ground and the negative battery terminal is the "hot" terminal. You may need to polarize the generator. This is doen by momentarily Jumping a wire from the bat terminal on the regulator to the gen terminal. You will see a small spark. DO NOT touch any other terminals or ground any of the regulator terminals, or you may ruin the regulator or the generator.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|