Farmall & IHC Tractors Discussion Board |
Re: Will It Fit?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike on March 28, 2001 at 08:36:58 from (209.50.141.75):
In Reply to: Will It Fit? posted by Wildbill on March 27, 2001 at 07:54:07:
The 560 gas motor will fit. I think the diesel will too, but I'm not as familiar with it(i think they are the same basic block too, but not sure). You will need to use the frame rails and backing plate from the 460 though. The block length, width, and height are identical, as are the holes that bolt onto the backing plate. The only think I'm not sure about is the front timing cover that bolts to the frame rails. I think that may need to be changed, but not sure. A 301 motor from an 806 will also fit in, but the bigger you go, the harder it will probably be to keep cool. The rear-ends from the 460 and 560 are different - just a miniature version basically in the 460. For tractor pulling purposes though it makes a cheap 80hp tractor that can get down to 4500 pounds pretty easily.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|