Farmall & IHC Tractors Discussion Board |
Re: Hydraulics Farmall 350
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dick on March 26, 2001 at 07:00:00 from (63.120.111.98):
In Reply to: Hydraulics Farmall 350 posted by Richard on March 25, 2001 at 17:21:25:
I think the pressure control on your tractor is the same as on the utility versions: pressure control to the power steering and to the rest of the hydraulic system are all tied together in one assembly. The way it's supposed to work is that the power steering gets priority, and if it doesn't need pressure, or all the flow, the rest of the system is supplied. Sounds as if "something" like the portion of the system which is supposed to direct flow to the power steering only when it's needed is stuck open; this would force the pressure relief valve in that portion of the system open to relieve the pressure from the fluid which has no place to go - and that relief valve being open would keep the pressure in the rest of the system low. In any case, I'll bet the solution is to tear into the pressure control portion of your hydraulics system. Good luck, and take a good look at the Service Manual for your hydraulics system.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|