Farmall & IHC Tractors Discussion Board |
Re: Hydraulics and engine load.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dick on March 25, 2001 at 07:44:44 from (63.120.111.98):
In Reply to: Hydraulics and engine load. posted by Rick on March 24, 2001 at 15:10:13:
Rick: From your description, I suspect that you have an obstruction in the line going to your cylinder. If the engine gets loaded up when you are raising or lowering the lift without anything on it, chances are that the pump is putting out high pressure which isn't making it to the cylinder because of an obstruction, and the system's high-pressure relief valve is (correctly) relieving this pressure before it gets dangerously high - but putting out this high pressure makes the engine work hard. If you don't notice any difference between how the system acts in the middle of the cylinder's travel, and at the ends of its travel, an obstruction is almost certainly the problem. Another tipoff is if the rate at which the cylinder moves is very slow. The obstruction could also be in the control valve somewhere. If you have more than one circuit in your hydraulics, a check of how one performs versus the other would be informative. Hope this is somewhat useful. Let us know what you find.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|