Farmall & IHC Tractors Discussion Board |
Re: Cylinder Pressure
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bama Binder on March 21, 2001 at 08:33:56 from (206.5.110.200):
In Reply to: Cylinder Pressure posted by REA on March 21, 2001 at 08:09:00:
The shop manual should have the pressure specs on the specific engine you have. My Super H has almost exactly 120 PSI across the board and I think the compression ratio was approx the same at about 6.5:1. My cub manual states that 120 PSI is normal for the Cub and it too is 6.5:1. To answer your question, 95 does seem a little low, but there are variables that com into play. Did you put in new pistons? If so were they the same as original. Is the head gasket the same as the original or is it thicker? The rings and valves can be in perfect condition yet you only have 95 PSI due to other things. My guess is you won't notice any real power difference and the lower compression engines actually "lug" better than high compression. Others will no doubt add to this or correct me if I have erred...BB
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|