Farmall & IHC Tractors Discussion Board |
WD-9 rear-main access
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greg Robinson on March 20, 2001 at 07:52:32 from (216.43.28.206):
As I previously posted, I am in the process of putting a new rear bearing and main seal in my WD-9. I was informed that access could be made throught the top of the clutch housing area... I have attempted to remove the housing cover closest to the enging, but the belt pully assemble is blocking access to one bolt... I began to remove the belt pulley assebly but there seems to be bolts holding it on that are threaded up from within the transmssion area (ie cannot access them)... so finally I began to remove the cover that the steering column is mounted to and the shifting linkage travels through, but I can't seem to get the shifting linkage to uncouple from the transmssion. Any advice would be greatly appreciated. Thank you in advance for your time (again)
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|