Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Moving Cottonpicker


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Harold H on March 19, 2001 at 12:55:40 from (207.244.55.95):

In Reply to: Moving Cottonpicker posted by Tom on March 19, 2001 at 08:21:24:

Tom,

We used to use a cotton picker trailer which was a special made trailer with three wheel wells which made the picker wheels very close above the pavement. (If you are in cotton country you can probably find a dealer with one of these trailers). This lowered it enough for clearence to most locations. Even then in some cases it was necessary to remove the basket top and fan blower housings. You can turn the top upside down in the basket. In order to haul it on a regular flat bed you may to take off the basket. Measure heights of clearance along your route and maby you can get away with only removing the basket top and fan blower housings. Be very careful. Once years ago our driver was hauling one on I-55 in Arkansas. He had stopped at several overpasses as he came to them and looked and the picker barely cleared the overpass. Finally he decided that all the I-55 overpasses were the same height and didn't stop for one. Guess which one was lower and didn't clear! If all else fails you can drive it if you pick roads away from the Interstate. We would sometimes drive them from the factory north of Memphis to just inside Mississippi (about 20 miles) and load them there and haul them rather than trying to get permit to haul them thru Memphis. (They were usually shipped to us by rail.) They will run 15 or so mph so you could make it in two days if you have to do this in lieu of hauling it.

Harold H


Follow Ups:




Post A Followup

:
:

: Re: Re: Moving Cottonpicker

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy