Farmall & IHC Tractors Discussion Board |
1944 Farmall A crank dimensions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John on March 14, 2001 at 16:57:31 from (205.188.200.46):
Does anyone know what the main bearing journal and rod end journal dimensions were on the '44 Farmall A crankshaft when it was originally made? I don't believe mine has ever been apart but am not sure. The plastigage clearance is between .005 and .006 on the main bearings with the old bearings in place. I want to know how much of this wear is bearing (probably most) and how much is journal wear. The journals look REAL good so i don't plan on a grind. I don't rule out a previous grind job so I really need the original spec dimension before I order new bearings. I've searched this site and only found previous advice to search out a machinist. Please help. Thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|