Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Re: Re: Re: Re: H Farmall cottenpicker


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Theman on March 13, 2001 at 10:58:06 from (204.149.23.2):

In Reply to: Re: Re: Re: Re: H Farmall cottenpicker posted by Glenn on March 13, 2001 at 05:48:29:

Glenn, Yes, the seat was turned around and on a separate (raised) platform. My grandfather had four of these machines on the farm southeast of Bakersfield, CA. Two were on M chassis and two were on Super M chassis. Only one time did he remove the basket and platform to use it as a row-crop tractor. It was just too much hassle to change back and forth. I'm not certain how travel direction reversal was accomplished but I do know when it was changed over there were 5 speeds in the direction the seat faced.

The belly pump operated two hydraulic circuits through a selector valve. One circuit raised the drum and the other dumped the basket. Being single acting, the basket had to be pulled back over center by hand if you were parked on an incline.

I remember spending many hours perched atop the blower housing behind my Dad watching row after row of cotton disappear below him. As a kid it sure was neat to spit over the side from that height...until I got caught one time.

It was the first piece of machinery I ever 'steered.' He told me to keep the row going between those "pointy things" in front. We quit growing cotton by the time I got to first grade.

There is a good picture of one on the back cover of Red Power magazine a couple of issues back.


Follow Ups:




Post A Followup

:
:

: Re: Re: Re: Re: Re: Re: H Farmall cottenpicker

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy