Farmall & IHC Tractors Discussion Board |
Re: Farmall 560 - new rearend or not?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George 2 on March 12, 2001 at 20:06:43 from (216.46.140.186):
In Reply to: Farmall 560 - new rearend or not? posted by Brent on March 12, 2001 at 12:07:04:
Brent: Yours has all the updates from the factory and they are one strong rear end. You have nothing to worry about. I have seen these rear ends survive for years with a turbo on the tractor and pulling 4 furrow 14 inch bottom plow in clay. The proof is with the tractor pullers. They are a favorite with them since they stand up to the abuse. It still doesn't hurt when you have the brakes off for disk replacement to check the bull pinion bearings for any radial looseness. If they are loose change the bull pinion bearings. They along with the axle bearings were the chief causes of the failures with the early 460's, 560's, and 660's
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|