|
Farmall & IHC Tractors Discussion Board |
Is this a Super A or just an A?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ty on March 11, 2001 at 08:31:16 from (216.90.51.9):
I have what I think is a super A. The main question is with the standard hydraulics. When they came out with the Super A in 1952, was there a point in which the carry over model 51 or early 52's come without standard hydraulics? I have had this tractor for 4 years and have pulled whatever available numbers off it to confirm it with the local case/ih dealer. They indeed told me it was a 1952 Super A. I purchased the manuals and noticed there were no hydraulics on the tractor as depicted in the pictures. It does however have an aftermarket hydraulic system and was converted to a 12 volt system. All original electronics do not appear as original as well. In addition it has the Super A sticker on it, but everyone knows you can slap a sticker on anything to confuse you. Another interesting piece of info on this was this past summer I replaced the Head gasket and noticed a patched up hood on the right side. You could not tell from the outside, but it had a round hole in it for which it had previously ran on distillate fuel. Many if not all parts seem to be interchangable with all years of A's and Super A's, so that seems to make it even more difficult to determine what year it is. It does not have a water pump as well. Where the original seriel numbers should be on the seat bracket is missing, so as to complicate identifying it as well. If there is any other data or thoughts on this, it would be most appreciated from everyone. Thanks,
Ty
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
