Farmall & IHC Tractors Discussion Board |
Re: Re: 450 cranking compression
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George on March 09, 2001 at 07:46:30 from (207.75.138.46):
In Reply to: Re: 450 cranking compression posted by standard gas? on March 08, 2001 at 10:57:13:
Shannon: My 450 runs real good and it will pull 4-14 John Deere trailer plow in 1st gear, admittidly not as easy as my J.D.70D in 3rd. BUT the Deere has 95 cu. in. more so it should and does pull stronger. The 450 came with a 3-14 mounted and it pulls that just fine. We have hard gumbo clay that takes a lot of power is the carb set ok? this can cause power loss good luck and keep us posted as to what you find
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|