Farmall & IHC Tractors Discussion Board |
Re: Loose fan belt on Super H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on March 05, 2001 at 17:15:24 from (66.66.72.246):
In Reply to: Loose fan belt on Super H posted by Joel Ottosen on March 05, 2001 at 13:02:33:
Joel - The fan/water pump pulley is a "split flange" variable pitch type. The front (radiator) half of the pulley is threaded on the fan hub. By holding the fan blade fixed and turning the front half on the hub, the front flange can be moved toward to the rear flange which in turn will tighten the belt. Before you can adjust the flange, you must loosen a set screw that holds the front flange in place. Back the set screw out all the way, then shoot a blast of Thrust, WD-40 or something in the hole to lube the fan hub threads. If you're lucky you'll then be able to adjust the front flange. Be sure to replace the set screw and locknut when you're finished! Note - the generator belt tension is adjusted same way, with a split flange on the generator shaft.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|