Farmall & IHC Tractors Discussion Board |
Re: Re: Super C front end
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on March 03, 2001 at 19:43:29 from (129.37.117.89):
In Reply to: Re: Super C front end posted by DAve G on March 03, 2001 at 18:44:15:
I think the B is different. I have a C and took the whole front end apart. The way the gears and shafts are built, I don't think there is a seal on the shaft that goes to the wheel post. It's built and splined so that the oil level is below where the seal would be. I think there is just a bushing. Yes you are correct about the way to take it apart. Take that round plate loose on the bottom and the bolt in the center loose and the whole thing will slide apart. On my C, the only seal I replaced was the steering shaft seal. On the other hand, maybe I missed something and was just lucky. Nothing leaks.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|