Farmall & IHC Tractors Discussion Board |
Re: Farmall H overhaul
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on February 25, 2001 at 21:03:24 from (208.49.9.46):
In Reply to: Farmall H overhaul posted by Rick in Kansas on February 25, 2001 at 19:40:45:
Rick, The manual (IT-IH-8) says that for the H prior to serial # 391358, main journal diameter is 2.4975-2.4985. What did the old bearings you took out say on them? STD means standard and is probably what you had in it if the crank has never been turned. Recommend you mic the crank and then order appropriate bearings or else use plasti-gauge when installing the new main caps. The running clearance for the H main bearings is .002-.003" for those prior to ser. # 391358. By the way, main bearing torque on the H is 75ft.lbs.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|