Farmall & IHC Tractors Discussion Board |
Re: Re: 3pt add on to IH Fast Hitch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gibby on February 24, 2001 at 17:40:29 from (198.144.79.154):
In Reply to: Re: 3pt add on to IH Fast Hitch posted by dick on February 24, 2001 at 08:35:55:
To mount the three point implements on the fast hitch by myself, I placed the 3 point conversion arms on the implement and let them rest on the ground. Then I lowered the Fasthitch as low as I could get them. I then backed the tractor up to the just past the tips of the 3 point arms. I then removed the arms from the implement and put the tips in the fast hitch arms and mounted the arms on the implement. I then started the tractor and backed it up a little and then raised the fast hitch - all the while backing up to the implement. Once it was locked in place, I connected the top link. Seemed to work fine for me.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|