Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall C rear axle seals
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on February 21, 2001 at 15:05:01 from (129.37.117.99):
In Reply to: Re: Farmall C rear axle seals posted by Kenneth Cronk on February 21, 2001 at 14:38:18:
I went to the IH dealer today to buy seals. I looked at the parts book and there is indeed an inner seal at the transmission. It must be holding because there are no leaks around the axle housing and nothing is coming out the ends where I took off the outboard seal holders. I am going to just replace the outboard seals and shoot it full of grease. I do have a transmission leak somewhere at the back in the PTO area. Have not cleaned that up enough yet to figure out where it is coming from. I suspect the PTO seal, or maybe the gasket where it mounts. The guy I bought the tractor from claimed the tranny had been rebuilt because a bolt had been dropped in it and it got in and ruined the trans. Maybe he replaced the inner seals then. Anyway, the transmission does not make excessive noise and shifts and pulls ok.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|