Farmall & IHC Tractors Discussion Board |
Re: 856 international farm tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on February 17, 2001 at 20:25:21 from (216.196.12.223):
In Reply to: 856 international farm tractor posted by kevin on February 17, 2001 at 15:37:50:
IS there a littel ball point pen spring under the MCV in the lower right hand conner and a plastic plug with a stem in the center of it , that is your sump check plug if it is missing re place it if it is there look at it closeley and see if it is damaged also make sure that it seats good. IF you have a pressuer gauge take pressure check off the bottom plug ,you will probable have to get a fitting and make up the hook up most people don't have all the tools and equipment to do most of the testing on hdy. systems and it can get into alotof testing to find a problem like flow rateing of the pump or system ,even i don't have it all yet but working on it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|