Farmall & IHC Tractors Discussion Board |
Re: zenith carburetor adustment
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Phil Auten (TX) on February 17, 2001 at 11:54:21 from (64.217.53.99):
In Reply to: zenith carburetor adustment posted by Jerry on February 17, 2001 at 11:02:13:
Jerry, Sounds like a couple of things. The gas dripping out of the weep hole indicates that your needle/and seat aren't sealing. Either replace them with one with the viton tip on the needle or take a plastic mallet and give the needle a couple of light taps to form them together so they will seal (ONLY if the needle is brass). The plug fouling is pretty normal for a tractor that doesen't get worked hard, like plowing all day. Try changing to a set of plugs that are at least two heat ranges hotter than standard, eg: Champion D15Y are standard, try a set of D18Y or D21Y instead. I use D21Y in all my IH tractors and they don't foul out. Same for my AC tractors, except the plugs are a different type. This has stopped all the plug fouling problems for me. Phil
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|