Farmall & IHC Tractors Discussion Board |
Thanks to all on Need a Fix for Weeping rearend
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on February 12, 2001 at 19:57:01 from (208.49.9.141):
While waiting for my welder friend to show, I started to change the front transmission seals on the countershaft and the upper tranny driveshaft. Got the nuts off of the driveshaft coupler but can't get the bolts out. Is this a "Must split tractor" scenario? IT Manual is worthless in this area. It appears that the bolts are pressed into the coupler halves. It also appears that the upper bearing will have to be replaced as there is a lot of play in the driveshaft of the tranny. By the way, the hole in the rearend housing is just a pin hole and not a crack. Don't think it will take much to seal it up. Rearend and tranny are drained, PTO is out and internals are wiped out clean. Thanks all.//FB
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|