Farmall & IHC Tractors Discussion Board |
can't get seal off counter shaft of SM
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe Berendzen on February 09, 2001 at 08:17:11 from (216.152.11.73):
I have the Liftall out of my SM and have taken the top trans. shaft seal off with no problems. My counter shaft does not have a nut as shown in my I&T shop manual. It only has a 1/2" solt which a cross coupling piece mates the counter shaft to the input shaft of the liftall. Is the shaft threaded and the end that I'm seeing basically a nut with a slot in it? I have the three bolts out of the bearing retainer and it is loose, but won't slip off of the front end of the counter shaft. Any help will be appreciated. Joe
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|