Farmall & IHC Tractors Discussion Board |
Clutch replacement
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Button on February 08, 2001 at 18:16:07 from (205.188.197.168):
John Britt said he had clutch work done now tranny slide out of gear. Make tis tip of the day. When going back together after split at the clutch on all of the tractors with Hyd Torque depress the fingers on the pressure plate and but a block between back of finger and back plate of pressure plate to hold springs depressed, put pressure plate Assy. on PTO drive shaft put drive member on tranny input shaft. Now put tractor back together at the split and bolt it together then go up through the inspection hole from under neath and bolt clutch to flywheel the blocks will fall out when you bolt the clutch to the flywheel. If you put the clutch on the flywheel then put tractor back together there is a good chance of pushing the tranny input shaft back into the TA now you have an other problem. don't know if this is John's problem.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|