Farmall & IHC Tractors Discussion Board |
MY M STILL SMOKES
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BRIAN on February 08, 2001 at 17:49:34 from (63.25.211.89):
I HAVE A 1950 MODEL M THAT I JUST OVERHAULED AND I HAVE ONLY RAN IT FOR ABOUT 45 MINUTES AT IDLE SPEED AND HALF THROTTLE. I HONED THE CYLINDER CHECKED ALL MAIN BEARING CLEARANCES AND EVERYTHING WAS ALRIGHT. MY QUESTION IS THAT WHEN I START IT I GET A PUFF OF SMOKE THEN IT CLEARS UP. I HAD MY VALVES CHECKED THEY WERE FINE,AND I INSTALLED THE RINGS SO NONE IF THE GAPS WERE CLOSE TOGETHER. WILL THIS CLEAR UP AS I RUN THE TRACTOR MORE. WHAT IS THE BEST WAY TO BREAK THIS TRACTOR IN . IM GETTING READY TO PUT A MAIN SEAL IN IT AND HAVE THE STEERING OUT OF IT SO I CANT TAKE IT TO THE FIELD THANKS FOR ANY ADVICE YOU CAN GIVE ME. BRIAN
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|