Re: Removing Pistons Question!

Posted by scott m on February 05, 2001 at 19:08:49 from (216.89.117.237):

In Reply to: Removing Pistons Question! posted by Scott S. on February 05, 2001 at 09:32:57:

rebuilding an h is not a great big feat. just trash the pistons and sleaves if they are that bad, it just make sense to put that much work in something that will just eat up a new set of rings. use a piece of 3/8 x 1" flat bar to pound the pistons out from the bottom you will be able to slide it next to the connecting rod so that you beat on the bottom of the top of the piston,that will get them out without any damage to the rod.
if you take the input shaft of at the flex joint you will be able to crack the tractor without having to remove the clutch and pressure plate.
if you check the size of the journal on the crank you should be able to tell if you need bearings, they make bearings that are -.002 if your crank has some wear on it.
when i bought my engine rebuild kit it came with everything i needed to do a total overhaul,

Follow Ups:

• Re: Re: Removing Pistons Question! Yellott Canby 19:44:47 02/05/01 (0)
• Re: Re: Removing Pistons Question! Yellott Canby 19:41:30 02/05/01 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Removing Pistons Question! Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]