Farmall & IHC Tractors Discussion Board |
Re: Removing Pistons Question!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on February 05, 2001 at 15:13:52 from (209.130.148.14):
In Reply to: Removing Pistons Question! posted by Scott S. on February 05, 2001 at 09:32:57:
You may want to get out the rusted pistons and see what you have. I had a very rusted pistion in my W30 and when I got it out the sleeve was rusted bad enough it had to be replaced. Have you taken off the head? If there is water sitting in the pistions then spaying penetrating oil won't do much. I would think having it done by someone else will cost an arm and a leg. One option could be to buy a rebuilt block and head from Central Tractor. Thats not cheap either but you can compare the catalog prices with what ever a shop quotes you. I had a shop rebuild the head on my 300U. When he got done he charged me the same money as the rebuilt one from Central Tractor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|