Farmall & IHC Tractors Discussion Board |
Re: timing tractor farmall A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on January 31, 2001 at 21:12:54 from (158.252.164.139):
In Reply to: timing tractor farmall A posted by Max on January 31, 2001 at 18:50:42:
If the A is the same as a Farmall B you need to remove the little oval cover at the bottom of the clutch bell housing and look for the DC-14 mark on the clutch housing. The DC1-4 mark aligns with a stationary index at the very bottom when No 1 and No 4 cylinders are at TDC. Take the spark plug out of the No. 1 cylinder (cylinder closest to the gas tank) and watch for the piston to get at the top of the compression stroke and then look up into the bottom of the bell housing and you should be able to see the markings. Static time it at DC-14, at high speed it should advance to something before DC-14. I'm not sure right off what the advance should be. Good Luck - you'll need a flash light.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|