Farmall & IHC Tractors Discussion Board |
Re: 460 and 560's as pulling tractors
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny Frisk on January 31, 2001 at 07:58:41 from (12.4.181.2):
In Reply to: 460 and 560's as pulling tractors posted by Charlie on January 31, 2001 at 05:32:21:
The problems were the result of LONG TERM loading of the tractors in heavy pull situations. IHC rated the 560 as a 5-bottom tractor when they came out. It was a 2nd gear load which put a TON of stress on the gears, shafts, & especially bearings. Most 560's ended up pulling 4-bottom equip in 3rd gear. with decent durability records. Tractor pulling is a contest of ULTIMATE STRENGTH, and durability is secondary. They get worked on constantly anyhow looking for an Edge over the competition. The same bearings, shafts & gears get stressed to their ultimate strength and fail for other reasons.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|