Farmall & IHC Tractors Discussion Board |
Re: Increase Hp on a Farmall M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bryon on January 30, 2001 at 12:51:51 from (205.221.191.28):
In Reply to: Increase Hp on a Farmall M posted by Don on January 29, 2001 at 19:37:26:
If you're just looking to have fun, easy things first. 1. Forget the octane booster, anything above 90 gas is just blown out the exhaust pipe. 2. Straight pipe, no muffler. reduce backpressure as much as possible. 3. Open up the gorvernor. I expained this in an earlier string. basically, pull off the cover, back set screw out, try up 4 or 5 turns of the spring. 4. Hotter plugs and coil. 5. Open airway to carb 6. Good used tires. Don't go with new ones, they'll spin easier. If you want to get into the engine a little. 1. Set cam off by one tooth (talked about in an earlier string) 2. Bigger pistons, 4" rebuild kit or bigger. 3. Drill out carb jets 4. Lighten up tractor and drop weight classes Medfarm was right about the weight distribution. you want most of the weight on the rear, so you just carry the fraont tires. Check the strings on the pulling discusion board. Some of them are good.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|