Crawlers, Dozers, Loaders & Backhoes Discussion Board |
Re: JD 1010C reverser woes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John de Marrais on May 05, 2003 at 16:03:58 from (209.23.9.153):
In Reply to: JD 1010C reverser woes posted by Daniel on April 30, 2003 at 12:34:48:
I've rebuilt a lot of these reversers and there are many things that can cause your problem. Probably the noise you hear is the clutches in the forward clutch pack. Likely you've got low pressure. It's easy to check but, at this point, turning up the pressure probably won't help. The internal components are mostly made by Twin Disk Company, but I don't know of a good parts source other than John Deere. It is a very strong reverser; much better than what was used in the 440. The 1010 and the 350 use the same components, but some early 1010 suff gets updated to some 350 items. If you decide to pull it apart, and want advice or instructions along the way, ask me. It's a fairly simple device; input shaft, output shaft, a counter shaft, and two clutch packs. I'm not counting the control valve assembly on the outside. It wouldn't hurt to see if your main pressure, when hot, is between 125 - 150 psi when hot. You might also want to check the forward-reverse trimmer screw.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|