| |
1941 Ford 9N Antique Tractor
| This tractor was purchased by my father in 1978, and had the engine rebuilt at that time. It has served well until last spring when I decided to rebuild it to withstand the rigors of bush hogging. I converted the tractor to 12 volts, replaced the entire wiring harness, added lights, a new radiator, new starter bendix and ring-gear, clutch, clutch release bearing, clutch shaft (rebuilt), rebuilt the rear end, added sure seals and replaced all rear end gaskets to stop a massive hydraulic fluid leak, replaced the pto shaft with standard size, added ORC etc etc etc. Most importantly I added stabilizer bars and a Zane Thang to the lift mechanism. Don't ask what it cost, but be sure that it works circles around tractors half its age. It moved all that snow! Submitted by Gordon Earl, from ON |
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|