TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Tractor Talk Discussion Forum

Case 1030 split and engine rebuild questions

Welcome Guest, Log in or Register

Author

Dairy Farmer in

02-15-2008 19:03:44

Report to Moderator

OK so i got my case 1030 all torn apart and the "new" block will be done on WED of next week. i ordered a new clutch and pressure plate today. BUT my mechanic that is helping me says that i should put a whole new oil pump in too. BUT a new oil pump is $700!! should i get a new one or just put a pressure gauge on it? if i did the gauge, where would i put the line that connects to the gauge? thanks
DF in WI

[Log in to Reply] [No Email]

JMS/.MN

02-15-2008 21:54:32

Report to Moderator

Re: Case 1030 split and engine rebuild questions in reply to Dairy Farmer in WI, 02-15-2008 19:03:44

Your mechanic should be able to show you the tech manual and the spec"s--how to measure wear between the gears and housing, as well as the allowable end play on the pump. Went through that about a decade ago on a 2470, and the pump was about $1100. Re: where to put the gauge? Many engines have oil gallery plugs, 1/8 inch, along the block, typically one per cylinder. I keep one on my JD4450, just for a visual when the Investigator II monitor craps out. I like mechanical things over electronics. Could very well be an age issue!.

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy