Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Tractor Talk Discussion Forum

Jubilee rebuild

Welcome Guest, Log in or Register
Author 
jubileejim

07-09-2007 18:25:43




Report to Moderator

I have a Jubilee ran several years ago but had to leave it for several years. It would not start, then found it had a stuck valve, on number two cylinder. Took the head off cleaned and reseated the valves. Took compression test, but only came up to 30 to 40 lbs per cylinder. I put motor oil in the cylinders, and did the check again they came up to 50 to 60 lbs per cylinder. So now I took the engine out pulled the pistons but three of the four pistons looked to have good rings, number four stayed compressed, I assume from carbon build up. I"m no mechanic, but when I took the head off I had oil on the head gasket where I didn"t think it should have gotten because I did tighten to the torque spec. 70 lbs. Any suggestions or thoughts on this?

[Log in to Reply]   [No Email]
old

07-09-2007 20:51:19




Report to Moderator
 Re: Jubilee rebuild in reply to jubileejim, 07-09-2007 18:25:43  
Sitting that long is hard on any engine. Oil doesn't work well to unstick things like the rings you found stuck. If you did thing right you probably could have got by with out even pulling the head off. I do lots of engines with the same problem and fill the cylinders with tranny fluid sine it will loosen up a lot of parts. But now that you have it apart you will better off to rebuild the engine and be done with it

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy